SatNOGS


Hardware This category should be used for topics related to support and development of SatNOGS Hardware. Software This category should be used for topics related to support and development of SatNOGS Software.
About the SatNOGS category [SatNOGS] (1)
Newbie Help Required Please [Software] (5)
What is a "good" observation? [SatNOGS] (11)
Logging show errors [Software] (2)
Can I use SatPC32 with my SatNOGS rotor? [Software] (15)
Hamlib: LX-200 protocol [Software] (6)
Tested and recommended LNA's? [Hardware] (1)
Satnogs Network Monitor ( 2 ) [Software] (21)
I'am back from the AMSAT-F meeting in Paris [SatNOGS] (2)
Meteor MN2 decoder for rpi 3B+ ( 2 3 ) [SatNOGS] (53)
Connecting antenna to RTL-SDR modem [Hardware] (10)
Soundcard input configuration using a Kenwood TS-2000 [Hardware] (3)
Where are the STLs? [Hardware] (8)
V3.1 - sources for North American builder [Hardware] (6)
RAMPS 1.4 Board for Satnogs Rotator [Hardware] (5)
Ansible_distribution Error. Client installation on Ubuntu 16.04 [Software] (4)
3d parts all slightly off [Hardware] (3)
A new version of 5.18 geared nema rotator [Software] (5)
Ogg artifacts frequency offset [Software] (1)
Waterfall and audio clip length [Software] (11)
Triplexer VHF/UHF/L or S Band [Hardware] (6)
Encoder Gear Homing Pin [Hardware] (4)
Rotator V3.1 BOM Clarifications [Hardware] (4)
Is it possible to schedule an observation without the doppler correction? [Software] (11)
Network Downtime 2019-03-07 [Software] (4)
PCB Wiring - Fuse [Hardware] (4)
Couple of Newbie Questions [Hardware] (5)
New Patch Antenna [SatNOGS] (4)
New Antenna: Discone Antenna [SatNOGS] (6)
Arduino pro micro burned and problem with pcb [Hardware] (6)