Integrating Satnogs with other rotators

I’ve built myself a low cost rotator based on a design from SARCNET (School Amateur Radio Club) here in Australia. It’s not waterproof, so can’t be left outdoors, but I’d like to use it for demonstrations etc.

It connects via USB using the EasycommII protocol. Am I correct that Satnogs uses Easycomm III protocol? Am I able to easily integrate this?



Nice rotator build!
In hamlib rotctl instead of using -m 204 (for easycommIII) use -m 202 (for easycommII).
Also take a look in satnogs wiki client.

1 Like