Hello @bali ,
I had been meaning to try this for quite a while, but kept putting it off because I was busy. I have now successfully used your scripts and setup to automatically receive and decode Meteor LRPT with SatDump on my VHF SatNOGS ground station (Station 4434)!
There is still some tuning to be done, especially regarding reception quality, but the whole workflow now works end-to-end: reception with SatNOGS, decoding with SatDump, image generation, and uploading the resulting artifacts back to SatNOGS.
・Meteor-M N2-3
SatNOGS Network - Observation 14926076
・Meteor-M N2-4
SatNOGS Network - Observation 14926066
The main changes I made to adapt the setup to my environment were:
- Changed the output and IQ file paths to locations under /var/lib/… to match my current Docker setup.
- Changed the CelesTrak URLs from http:// to https://.
- Added a process to write the TLE used by SatNOGS for each observation directly into SatDump’s local TLE file.
- Added a 30-minute timeout and forced-termination handling for SatDump, so that a stalled SatDump process does not block subsequent SatNOGS observations.
I also used ChatGPT for some assistance while troubleshooting and implementing these changes.
Thank you very much for sharing your scripts and setup!
Best regards,
Kazuki NISHIOKA, JF6FYI

