SatNOGS Ground Station Antenna and Rotator Hardware Assembly Help

[bali]

@kpin404

Does SatNOGS sell-off these outdoor antenna assembly parts to build

what i know they create the kit, ussualy can be found at big amateur events but not rotator.

the kit:

V4 RTL-SDR Bias Tee Issue?

Since I can only post one image per message, here is what the setup looks like: Bill WT0DX [SatNOGS Test Install 4.28.26]

for rotator ussualy diy like this:

Our groundstation build progress and questions

Very nice station. Thank you for the tips. I am busy the next few days but I am already tinkering around with openscad to build some holders to fit everything together. Do you filter the power with ferrit beds or do you use any active filering, too? P.S. I assume the breadboard lower left is some sort of active filter?

SatNOGS Rotator v3.1 Build Project

Hello, I’m starting this thread to share and document my build of SatNOGS Rotator v3. I should’ve done it earlier, but I’m almost done with my rotator part. It’s mostly built on the v3.1 guide but I slightly modified it to adapt what I can sourced locally. I used aluminium extrusion corner bracket instead of T slot L bracket like in the guide as it was so expensive here it could cost almost half of the budget just for the L bracket . For the controller I used Arduino UNO and CNC sh…

73!