I’m assembling a SatNOGS rotator controller v2.4 and trying to wrap my head around the assembly but the changes between the v2.0 and v2.4 make the Wiki useless.
I guess my main question are that the v2 instructions talk about leaving off a few resistors if doing steppers, and some jumper settings for UART vs RS485.
Also, the microstep jumpers listed on that page are different on the V2.4 board (jp3-jp8) whereas on the v2.0 board they are jp1-jp6), but that’s easy enough to figure out.
Are there updated build instructions for the V2.4 controller somewhere?