Updated station with microsd card update as was on stretch, now on buster as the base ( as per option 2 of update directions)
re re run satnogs , everything looks ok , new menu shows
put in api key , etc as per guidelines , rebooted , power down etc …
station appears on network , in test mode but all observations blank
flushed usb … , all observations still blank ??
all sats tested are good performers usual at my location, a couple of purple results, mostly blank so reduced the gain to 11 as per instructions
rtrl test shows its good and working, same dongle as per always ( 7000+ observations) , usb unplugged etc all no improvement
all results still blank
station monitor 0.3.1 shows sats as they pass, no waterfall though ? not sure if this is a station or monitor issue ?
cant figure out how to post logs and screen shots, (advanced — support) , doesn’t produce any information, just sits there
Anyone any ideas have tried all the ideas in the other threads ?
else may have to start again from scratch with a fresh buster image ?
cheers