SatNOGS   Hardware


About the Hardware category (1)
Tested and recommended LNA's? (3)
V3.1 - sources for North American builder (10)
# The 3D printed ALUMINIUM TURNSTILE ANTENNA # for Ground Station (2)
Help with Monoprice Maker Ultimate + Cura 4 to print rotator pieces (6)
Recherche utilisateur en France (4)
Satnogs Rotator using an Arduino Uno and CNC Shield with A4988 drivers and Nema 17 steppers with Direct PC connection (3)
How to connect UART of Pi 3 B with a MAX485? (1)
Dreamcatcher hardware for a station (5)
SatNOGS rotator ROS controller (1)
Connecting antenna to RTL-SDR modem (10)
Soundcard input configuration using a Kenwood TS-2000 (3)
Where are the STLs? (8)
RAMPS 1.4 Board for Satnogs Rotator (5)
3d parts all slightly off (3)
Triplexer VHF/UHF/L or S Band (6)
Encoder Gear Homing Pin (4)
Rotator V3.1 BOM Clarifications (4)
PCB Wiring - Fuse (4)
Couple of Newbie Questions (5)
Arduino pro micro burned and problem with pcb (6)
Rotator control with stepper motor HAT/shield from Adafruit? (5)
Review of commercial rotator controllers (8)
Newbie interested in building a Satnogs Rotator -- with wayy too many questions :) (10)
Rotator 3.1 End stop switch mounting (1)
Rotator 3.1 Worm Gear Issues (10)
CNC/GRBL controller board? Other alternative cheaper parts? (5)
2m/70cm Diplexer ( 2 3 ) (45)
T slot 20x20 L100mm for Rotator v3.0 (2)
Rotor control and when it hits 0-360 point (2)